The two looms I own are the Schacht Baby Wolf and Schacht Mighty Wolf. The towels I’m currently weaving at a pace as slow as a snail are on the Baby Wolf which is a 24″ wide, 8 shaft loom. I only have 4 of the shafts threaded for this twill. I’m on the 5th towel of 10 (I think). I decided to try a twill pattern which requires 8 treadles to be used. For at least 2 of the treadles 3 shafts are raised at the same time.

When I took this loom out to thread it I noticed that my rubber bands at the back were all dry rotted so I removed them and just started weaving away happily with no issues, but then when I did the tie up for this current pattern I remembered why those rubber bands are helpful.

See all that space under the lower threads? Also, see how there’s no way a shuttle is getting through there? I wove a couple of picks, pushing down the offending shaft each time. Then i remembered the rubber bands.

And I decided to take my camera along so I could show what those holes in the back of the loom are for in case you were wondering.

Here’s my rubber band collection. You can use almost any rubber band as long as it will fit through the hole and they are all the same size.

One down….

There they all are threaded through the holes that are there for just this purpose.

Then slide the thin dowel through the top loop of the rubber bands which will hold them in place.

Now add a treadle tie cord to each rubber band.

And slide a tie up into each treadle.

So, what this does is when a treadle is pushed down on purpose, its neighbors don’t follow along because they are held in place by the rubber bands. But the bands stretch so when you actually want to push that treadle you can.

So now you know, if you have a loom like this and it came with all of those rubber bands, what to do with them!

Ok. I’m back to weaving!

Pin It on Pinterest

Share This

Share this post with your friends!